AMX APEX Destiny 6100 Especificaciones Pagina 8
- Pagina / 84
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
8
Specifications
Electrical: Voltage Input: 16.5 VAC 40 VA from supplied transformer
External Speaker: 10 Watt minimum, 8W horn type - Ademco 713 or equivalent. Total
speaker load must be between 4W and 16W.
Internal Speaker: Speaker supplied in all compatible keypads. For stand-alone operation
10 Watt minimum, 8W - Ademco 746 or equivalent. Total speaker load must be
between 4W and 16W. For UL installations, an Ademco 705 speaker must be connected to
the "EXT" and "COM" terminals.
Auxiliary Power Output: 13.5VDC, 1.85 AMP max - Not evaluated for UL installation
Switched Fire Output: 13.5 VDC, 1.85 AMP max
Two Wire Smoke Detectors: Up to 12 per system
Note: Switched Fire Output and Two Wire Smoke Detectors are not to exceed
10mA in a UL installation
Back-up Battery: 12VDC, 7AH gel cell. YUASA NP7-12 or equivalent.
For UL installations use 2 - batteries with SA5140-1 cable assembly
CAUTION: Total current draw of Auxiliary + Smoke + 4 wire bus power is not to exceed 2
Amps. In UL installations total current draw must not exceed 400mA. Test installation for 1
minute in alarm to ensure sufficient power.
Communicator: Supports: 3/1, 4/1/1, 4/2 extended, Ademco Contact ID
49 report codes
DTMF and pulse dialing
DPDT line seizure
Two telephone numbers and two account codes, dial both numbers
Split reporting of selected codes
Alternate number dialing if primary number fails
Programmable number of dialing attempts
Programmable to enable or disable the communicator
Two-Way Voice: Microphone inputs: 3 separate, individually controlled channels.
Microphone: 5V shielded 2 conductor omnidirectional electret condenser microphone.
Frequency response 50-10K. -64db sensitivity, TWM-25K or equivalent.
System Zones: 96 using the following inputs:
80 - programmable fully supervised wireless alarm points (with H series receiver)
16 - programmable fully supervised hardwire inputs on the control panel
64 - programmable fully supervised hardwire inputs on multiplexed expansion boards
1 - 2-wire smoke loop
8 - keypad alert
8 - wireless keypads (when available)
1 - local phone activation
1 - remote phone / phone line monitor activation
8 - X-10 sending units (Not UL listed for fire or burglary functions and are intended for
home automation.)
Auxiliary Outputs: 1 - Form C 10A 24VDC system relay
7 - Pull to ground, 12 volt, 100mA outputs, not to exceed 500mA total.
Not to be used in a UL installation
- DESTINY 6100 1
- Software Revisions 4
- Table of Contents 5
- System Options and Times 6
- Central Station Features 6
- User Codes 7
- Control Channels 7
- Specifications 8
- Inserting the Cabinet Lock 11
- Mounting the Control Board 11
- To House 12
- From Phone 12
- Wiring Notes 13
- System Terminals 14
- X-10 Interface Cord 16
- Program Mode 18
- Locations and Values 18
- Automated Locations 18
- Exiting Program Mode 18
- Programming 18
- Quick Start 19
- System Input Overview 20
- Programming System Inputs 20
- System Setup Example 21
- Using This Manual: 22
- Program a Zone 23
- Zone Questions 23
- * Zone Type 24
- Zone Options 1 24
- Zone Options 2 24
- Hardware Device Types 25
- Predefined Zone Assignments 25
- Hardwire Inputs 26
- 5816 (MN) 5817 27
- Button Type Devices 28
- Button Functions 29
- Editing Zone Programming 30
- Deleting a Zone 30
- Smoke Verification 33
- Speaker (Bell) Supervision 34
- RF Jam Detection 34
- System Options - Group 1 36
- System Options - Group 2 36
- System Options - Group 3 36
- System Options - Group 4 37
- System Options - Group 5 37
- System Options - Group 6 37
- System Access Codes 37
- System Times 38
- Monitor Trouble Conditions 38
- Bypass Options 38
- Phone Access Options 39
- Event Memory Log 39
- Communicator Times 46
- Two-Way Voice Options 46
- Two-Way Digit Assignments 47
- Report Codes 49
- Dialer Options 51
- Communicator Diagnostics 51
- User Communicator Test 51
- Central Station Terms 52
- Key Function Values 56
- Keypad Option 56
- Keypad Functions 57
- TS16 Group 1 57
- TS16 Group 2 57
- Keypad Area Assignment 57
- User Code + Digit Functions 58
- Extended Monitor Times 58
- Vocabulary 59
- Keypad Function Terms 61
- User Code Options 65
- Disappearing Code Activations 65
- Assigning User Codes to Areas 65
- User Code Terms 66
- Automation Overview 67
- Automation Example 67
- Channel Activations 68
- Control Channel Options 1 69
- Control Channel Options 2 69
- Control Channel Options 3 69
- Control Channel Options 4 69
- Control Channel Locations 70
- System Triggers 71
- X-10 Options 71
- Output Control Assignments 72
- Chain Group Assignments 73
- Control Channel Terms 74
- ADEMCO LIMITED WARRANTY 84
Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad AMX APEX Destiny 6100
(18 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.031 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales