AMX APEX Destiny 6100 Especificaciones descargar pdf (Pagina 55)

Fail to Open/Close

Fail to Open/Close: Fail to open/close will check system arming status at a programmed time and report to

the central station if the proper condition is not met. Program the option total in

location 0216. Use location 9994 to program the appropriate fail to Arm time followed

by the Disarm time in military format. For times below 10:00 use a leading zero. If

only one arming state is being monitored, still enter two times. If the option is not

selected the programmed time will be ignored.

Two-Way Digit Assignments

Two-way key functions: It is not recommended to alter the telephone digit assignments for two-way voice,

however, to conform to some central stations this process may be necessary. To

reassign the assignments, place a 001 in location 0222. Each of the two-way functions

are listed along with the digit assigned. By altering the location values, each function

can be reassigned to a new key digit. Take care when altering key assignments not to

program a single digit to have multiple functions. The system will only expedite one

function per telephone digit. Two-way voice is not evaluated for UL installation.

Dialer Options

Dialer Option: Each zone is individually programmed to report to the central station as well as each

zone type. If a zone is programmed to report to the central station and the zone type is

disabled or only programmed to report to the event memory log, the zone will NOT be

reported to the central station.

Dial phone number 1: This option tells the control panel to always call phone number #1 if the corresponding

zone type is the cause of an activation.

Dial phone number 2: This option tells the control panel to always call phone number #2 if the corresponding

zone type is the cause of an activation.

Dial alternate number: If only one phone number is selected and the system is unable to communicate, the

system will try to contact the second number.

Enable two-way voice: This enables two-way voice to be used after the digital communication to the central

station. To enable two-way callback refer to System Options Group 3.

Record in EML: The system contains a 511 Event Memory Log (EML). Reports that are sent to the

central station are available to be sent to the EML. Even if a report is not programmed

to be sent to the central station it may still be programmed to be sent to the EML. Each

report code can be recorded in the EML by adding the 128 value in the dialer option.

The only method for retrieving the EML is with the PC based programming software.

Once the EML reaches 512 events, all new events push out the oldest event. The EML

can be cleared by entering 9898 from the keypad or phone while in program mode.

Report Code: All events that initiate a communicator report are associated with a report code (based

on zone type) that appears at the central station. Each report code can be defined for

all report types except Contact ID. When Contact ID is used, no programming is

required.

The following abbreviations are used in the "Ademco Contact ID Codes" Chart:

Z - Zone (up to 3 digits)

U - User number

E - Event or open

R - Restore or close

S - Section number

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 83 84

Comentarios a estos manuales

Sin comentarios

AMX APEX Destiny 6100 Especificaciones Pagina 55

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad AMX APEX Destiny 6100