AMX APEX Destiny 6100 Especificaciones descargar pdf (Pagina 52)

Central Station Terms

Communicator Automated Programming Locations

Central Station Number: Space is provided for two 16-digit phone numbers. These numbers are programmed as

normally dialed. To enter communicator phone numbers, enter the appropriate 9000

location and enter the number. The system places the numbers in the appropriate

locations. There are characters that are available in the dialing string that are not found

on the keypad. The chart below explains how to enter additional functions:

Dialing Feature # or H Followed By

Dial * 1

Dial # 2

Wait for second dial tone 3

3 second pause in dialing sequence 4

After the number is entered, press # or H key twice to save. Pressing the * or A key at

any time during phone number will clear all digits that have been entered.

Central Station account: Each phone number has an account number associated with it. You may use a 3- or 4-

digit account number. If Ademco Contact I.D. is being used as the reporting format, a 4

digit account number must be used. The system allows additional characters as follows:

Hexadecimal Digit # or H Followed By

Speak phone number: To confirm programmed phone numbers, Enter the appropriate 9000 location and the

number will be spoken. Special dialing feature codes will be heard as follows:

Dialing Feature Spoken As

Dial * Star

Dial # Pound

Wait for second dial tone Tone

3 second pause in dialing sequence Pause

Speak account number: Speaks programmed account number.

Echo communicator: To listen to the communicator transmission through the inside speaker, enter 9960 while

in program mode. Each communication will be heard over the inside speaker. When

testing is complete, return to programming mode and enter 9960 to turn off the

communicator monitor feature. Communicator monitor automatically turns off when

the panel is turned off or when the two-way voice circuit becomes active. Whenever

possible use the communicator monitor feature instead of a telephone butt set. The

panels phone circuit is very sensitive to loading. A good test to attempt when

experiencing communicator difficulties is to remove all connections from R1 and T1

and connect only the panel to R and T. This ensures a good phone connection and can

help isolate troublesome connections.

Communicator Time Options

Delay before dial: For both phone numbers, the system will wait a programmed time period (1 to 255

seconds) after activation before dialing the central station. If a value of 000 is

programmed, the communicator is disabled. If an alarm activation occurs and the

system is disarmed before the delay expires, the system will not communicate to the

central station. Valid delay values are 1-255 seconds.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 83 84

Sin comentarios

AMX APEX Destiny 6100 Especificaciones Pagina 52