AMX NXV-300 Especificaciones descargar pdf (Pagina 9)

Installation

NXV-300 Modero Virtual Touch Panel

Installation

Wiring and Connections

The NXV-300 is installed to the NetLinx Master, and passes NetLinx control commands to the Master via Ethernet 10/

100 cable, as indicated in FIG. 3:

After you have completed the installation, consult the Setup Pages and Descriptions section on page 5.

Ethernet 10/100 Base-T RJ-45 Wiring Configuration

The table below describes the pinouts, signals, and pairing for the Ethernet 10/100 Base-T connector and cable.

PoE (Power Over Ethernet)

The NXV-300 uses CAT5/CAT6 wire via the Ethernet port for PoE power. The maximum power draw for the NXD-300

is 2.2 watts. Use the PS-POE-AF Power over Ethernet Injector (FG423-80) to simplify wiring and installation by

eliminating the need for an AC outlet at each point of installation.

If used with a non PoE-capable Ethernet switch, then an optional PS-POE-AF Power-over-Ethernet (PoE)

power supply is required to provide power to the NXV-300.

If the NXV-300 is used with a PoE-capable Ethernet switch, then no PoE Injectors are required.

To avoid any damage to the electronic component, installation must be performed in

an ESD safe environment.

FIG. 3 NXV-300 installation

Ethernet Pinouts and Signals

Pin Signals Connections Pairing Color

Diagram

1 TX + 1 --------- 1 1 --------- 2 White-Orange

2 TX - 2 --------- 2 Orange

3 RX + 3 --------- 3 3 --------- 6 White-Green

4 no connection 4 --------- 4 Blue

5 no connection 5 --------- 5 White-Blue

6 RX - 6 --------- 6 Green

7 no connection 7 --------- 7 White-Brown

8 no connection 8 --------- 8 Brown

Ethernet 10/100

PoE injector

NetLinx Master

Ethernet Switch

NXV-300

Ethernet 10/100

To Touch Panel

To Laptop

The NXV-300 can be placed up to approximately 330’ (100 meters) from PoE

Injector.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 79 80

Sin comentarios

AMX NXV-300 Especificaciones Pagina 9