AMX NXV-300 Especificaciones descargar pdf (Pagina 22)

Setup Pages and Descriptions

NXV-300 Modero Virtual Touch Panel

System Settings - Master Tab

The Master tab of the System Settings page contains the necessary information for connecting to the network Master.

The elements of the System Settings page - Master Tab are as follows:

System Settings Page - IP Tab Elements (Cont.)

Domain Sets the unique name on the Internet to the panel for DNS look-up.

• The panel belongs to the DNS domain.

Ethernet Mode Sets the speed of the Ethernet connection to the panel.

• Choices are: Auto, 10 Half Duplex, 10 Full Duplex, 100 Half Duplex, or 

100 Full Duplex.

MAC Address Displays a read-only field that is factory set by AMX for the built-in Ethernet interface.

Save & Reboot: Saves any changes and reboots the device in order to implement those changes.

Cancel: Returns to the previous page without saving any changes.

FIG. 17

System Settings page - Master Tab

System Settings Page - Master Tab Elements

Connection Status 

icon:

This visual display of the connection status allows the user to have a current visual update of the

panel’s connection status, regardless of what page is currently active.

• A Lock only appears on the icon if the panel has established a connection with a currently

secured target Master, which requires a username and password.

Type: Sets the NetLinx Master to communicate with the panel via Ethernet. This is based on the cable

connection from the rear.

• Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45 connector) used to network

computers together and is used in most LAN (local area networks).

Mode: Cycles between the different connection modes (URL, Listen, NDP(UDP), URL(UDP), and Auto):

• Auto - In this mode, enter the System Number and a username/password (if applicable).

This mode is used when both the panel and the NetLinx Master are on the same Subnet and

the Master has its UDP feature enabled. The Master IP/URL field is read-only because the

panel obtains this information from the communicating Master.

• URL - In this mode, enter the Master IP/URL, Master Port Number, and username/password

(if used) on the Master. The System Number field is read-only.

• Listen - In this mode, add the Modero panel address into the URL List in NetLinx Studio and

set the connection mode to Listen. This mode allows the Modero touch panel to "listen" for

the Master’s communication signals. The System Number and Master IP/URL fields are

read-only.

• NDP(UDP) - This mode uses UDP instead of TCP to access the device. The System

Number and Master IP/URL fields are read-only.

• URL(UDP) - This mode uses UDP instead of TCP to access the device. The System number

field is read-only.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Sin comentarios

AMX NXV-300 Especificaciones Pagina 22