AMX NI-3100 Especificaciones descargar pdf (Pagina 17)

Initial Configuration and Firmware Upgrade

NetLinx Integrated Controllers- WebConsole & Programming Guide (FMv3)

4. Click the Start Identify Mode button. This action activates Identify Mode on the named System.

The Device Addressing dialog displays the "Waiting...Press Cancel to Quit..." message, indicating that

Identify Mode is currently active (NetLinx Studio is waiting to detect a device - FIG. 5).

5. Press the NI Controller’s ID button to assign the new Device / System values entered in step 3 to the

Controller. At this point, the "Successful Identification Made " message is displayed (FIG. 6):

The previous Device and System numbers of the NI Controller are displayed below the red field.

Example: Previous D:S=5001:1,

where "5001" represents the previous device value of the

NI Controller (D) and "1" represents the

NI Controller’s System value (S).

"Identify Mode" means that the system is put on hold while it waits for an event from

any NetLinx device in the named system (for example, pushing the ID button on a

NetLinx device). The device that generates the first event is the device that gets

identified.

FIG. 5 Device Addressing dialog - Identify Mode active

FIG. 6 Device Addressing dialog - Successful Identification Made

Identify Mode is

currently active

Device identified

ID Mode no longer active

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 159 160

Sin comentarios

AMX NI-3100 Especificaciones Pagina 17