AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones descargar pdf (Pagina 18)

Installation and Wiring

PT10-PLV Single Camera Pan/Tilt System

! AXlink data lines (AXM and AXP) are designed for balance-line operation; wire the data

lines in the same twisted pair.

! Use a shielded cable for best results, both to reduce electronic interference radiated by

adjacent wiring and to eliminate noise from AXlink cabling to adjacent audio cabling.

If you find that the included 100' (30.48 m) AXlink cables are not long enough for your application,

use the wire types suggested below to make custom cables.

AXlink - (local-area, low-power requirement)

22/24 AWG 4-conductor cables can be used for short wiring runs.

! Level 3, 4, or 5 unshielded, twisted pair

! Belden 8102, 2 twisted pair, 1 shield 12 pF/ft, PVC and plenum cable available.

AXlink - (local-area, high-power requirement)

Large systems that power many bus controllers or touch panels should use a heavier gauge wire to

handle DC power.

! Liberty Wire and Cable AMX-2S22218 AXlink Cable, one shielded, twisted pair 22

AWG, 12.5 pF/ft, two 18 AWG, PVC and plenum cable available.

AXlink - (wide-area, local-power supply)

In this type of system, power is rarely distributed over the AXlink bus; local power supplies are

used for each controller or linked system.

! West Penn D2401 1 twisted pair, 1 shield 14 pF/ft, plenum cable available.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Sin comentarios

AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones Pagina 18