AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones descargar pdf (Pagina 14)

Installation and Wiring

PT10-PLV Single Camera Pan/Tilt System

Wiring Guidelines

The PosiTrack Controller requires local +12 VDC power (optional) to operate properly. The

maximum wiring distance between the power supply and the PosiTrack Controller is determined by

power consumption, supplied voltage, and the wire gauge used for the cable. The following table

lists wire sizes and the maximum lengths allowable between the PT10 and the power supply. The

maximum wiring lengths are based on a minimum of 13.5 VDC, available at the power supply

output.

To reduce the possible effects of ground loop noise in the video, use a single-source power supply

mounted within distances specified below.

The PosiTrack Controller is powered from an optional local power supply. The wiring distances

listed for the AXB-PT10 in the above table are based on a +12 VDC power supply and are capable

of 2 amps (continuous) with a maximum current of 20 amps. The PosiTrack unit provides power

outputs for the camera/lens combination.

FIG. 10 Side view of the AXB-PT10 showing the location of the AXlink connector.

Camera control RS-232 DB-9

(male) connector

AXlink 4-pin (male) connector

When applying power to the AXB-PT10, adjust the soft-set pan/tilt-limit stops to a safe position to

prevent camera or AXB-PT10 damage.

Wiring Specifications - PT10

18 AWG 29.34 feet (8.94 meters)

20 AWG 18.56 feet (5.66 meters)

22 AWG 11.57 feet (3.53 meters)

24 AWG 7.30 feet (2.23 meters)

Do not connect power to the PosiTrack Controller until the wiring is complete. If using an optional

+12 VDC power supply, apply power to the AXB-PT10 only after installation is complete.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Sin comentarios

AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones Pagina 14