AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones descargar pdf (Pagina 11)

Installation and Wiring

T10-PLV Single Camera Pan/Tilt System

Mounting and Balancing the Camera/Lens

The camera/lens assembly should be mounted so the tilt axis is capable of going through the optical

axis of the camera, assuming the optical centerline is between ½" (12.70 mm) and 5" (127.00 mm)

above the mounting plane of the camera lens. The mounting platform (camera mount) allows the

camera/lens to be mounted with its center of gravity on the tilt axis. The maximum weight of the

camera/lens assembly is 10 lbs. (4.54 kg). The camera cradle is mounted to the Tilt Hub. FIG. 6

shows the dimensions of the Tilt Hub.

To mount and balance the camera/lens:

1. Remove the camera/lens cradle assembly by removing the four ½" screws and washers from

the tilt hub.

FIG. 5 PT10 and pedestal mount

Cradle support bracket

Wire

tie-mount

Camera mount assembly

Pedestal mount

The Camera/Lens cradle can be mounted on either side of the cradle support bracket.

FIG. 6 Tilt Hub dimensions

0.75"

(19.05 mm)

0.75"

(19.05 mm)

0.75"

(19.05 mm)

0.25"

(6.35 mm)

0.25"

(6.35 mm)

0.75"

(19.05 mm)

0.00"

0.56" (39.62 mm)

Camera points in

this direction

Do not lift the PT10 by the Camera/Lens cradle as this procedure damages internal components.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Sin comentarios

AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones Pagina 11