AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones descargar pdf (Pagina 12)

Installation and Wiring

PT10-PLV Single Camera Pan/Tilt System

2. Separate the camera mount and cradle support bracket by removing the two ½" screws on the

underside of the assembly (FIG. 7) using a 3/32 Allen wrench.

3. Install the camera alignment peg to the mount at the position that best fits the camera/lens.

4. Secure the camera/lens to the cradle (at the camera alignment peg) with the screw and fastener

supplied with the camera/lens (see FIG. 7).

5. Determine (and note) the center of gravity for the camera by using your finger to balance the

entire camera/lens and mount. The center of gravity is the location on the long axis of the

camera/lens assembly around which the camera balances.

6. Place the camera/mount in the appropriate location along the cradle support bracket so the

camera's center of gravity aligns with the horizontal tilt-axis, as shown in FIG. 8.

7. Re-attach the camera mount (camera/lens) to the cradle support bracket using the two ½"

screws.

8. Take the entire camera/mount and cradle assembly, and align the lens with the Tilt Hub, so the

vertical-axis intersects the center of the camera's iris, as shown in FIG. 9.

9. Mark the position of the cradle support bracket on the Tilt Hub (for later attachment).

FIG. 7 Camera/Lens cradle assembly (camera mount and lens mount)

FIG. 8 Aligning the center of gravity

Mounting holes (three sets)

Cradle support bracket

Camera alignment peg

Camera/Lens cradle

assembly (side view)

Camera mount

(underside view)

Camera and lens

Center of gravity (approximate)

Camera/lens

and mount

Horizontal

tilt-axis

Mount the camera as close to the Tilt Hub as possible to obtain a true center of gravity.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Sin comentarios

AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones Pagina 12