AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manual de instrucciones Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 30
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
Installation and Wiring
12
PT10-PLV Single Camera Pan/Tilt System
Wiring Information for the AXB-EM232
FIG. 13 shows the front and rear view of the AXB-EM232 and describes the features relevant to
this configuration.
The following table describes the blink patterns for the front panel AXlink LED.
FIG. 12 Mini-XLR connector wiring diagram
FIG. 13 Front and rear views of the AXB-EM232
AXlink Blink Patterns
One blink/second Indicates that power is active and AXlink communication is functioning.
Two blinks/second Indicates that power is active and AXlink communication is functioning, and that
the devices specified in the master program do not match the devices found. This
will be the blink pattern normally seen with PosiPilot camera control system
because the master program has the ability to control more devices than are nor-
mally present.
Three blinks/second Indicates that there is an AXlink communication error.
Full On Indicates that there is either no AXlink activity or that the AXCESS program is not
loaded.
1
2
3
4
4 - PWR+ (red)
3 - AXP (white)
2 - AXM (green)
1 - GND- (black)
4 PWR+ (red)
3 AXP (white)
2 AXM (green)
1 GND- (black)
To AXP-PLV
To Master Controller
AXlink LED - The green AXlink LED blinks to indicate
AXlink communication activity, power, and data status,
according to the descriptions listed below.
AXlink 4-pin captive-wire connector for data
and power (to AXB-PT10 and AXP-PLV)
2-pin captive-wire 12 VDC
power connector (from
PS2.8)
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

Comentarios a estos manuales

Sin comentarios