AMX AXD-CP4/PB Especificaciones descargar pdf (Pagina 198)

PSU - 12 Positioning Drive Setup Ver. 0002

PSU.5.3 ABSOLUTE FEEDBACK

The absolute feedback on Fagor FXM motors registers the value of their angular position along

more than 4000 turns and it does not lose it when turning the machine off. Thus, the drive

knows from the very first instant which is the absolute position of that axis.

To place the machine zero at a particular point of the axis travel, proceed as follows:

• Take the axis to the point selected as zero.

• Read the PV51 -S51- PositionFeedback1 variable

• Set parameter PP177 -S177- AbsoluteDistance1 with the value read in PV51.

PSU.6 BALLSCREW BACKLASH COMPENSATION

When the position feedback is obtained on the motor shaft, the ballscrew backlash must be

compensated for.

Feedback on the motor.

The drive can compensate for any backlash between the load and the ballscrew by internally

acting upon the position command. Thus correcting the movement hysteresis originated when

reversing the direction of the axis.

Set this parameter:

PP58 -S58- Backlash

This ballscrew backlash compensation only takes place if:

• the Drive is in position control mode and

• there is no feedback on the load.

Warning: Both the drive and the CNC offer parameters setting the value of ballscrew

backlash. This value must ONLY be registered AT ONE OF THEM. The other

parameter must be set to "0".

Load

Ball-screw

Backlash

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 363 364

Sin comentarios

AMX AXD-CP4/PB Especificaciones Pagina 198