AMX RPMLoader Manual de usuario descargar pdf (Pagina 15)

Configuring the NXB-CCG

RPM Device Configuration Guide - NXB-CCG NetLinx Clear Connect Gateway

Adding a Switch

RPM supports the CCD-RS switch (FIG. 34):

1. In the NXB-CCG’s WebConsole Add Devices page, click Add/Remove Devices to enter "add/remove devices

mode" (FIG. 35):

The program will indicate that it is entering "add/remove devices mode" (FIG. 36):

In this mode, the NXB-CCG will wait for a device to be identified.

When "add/remove devices mode" is active, the WebConsole will prompt you to press and hold a button on

the sensor (FIG. 37):

2. To add the switch, press and hold the main paddle button (see FIG. 34 on page 11) for approximately 4 seconds,

until the Device Heard popup appears in the WebConsole (FIG. 38) indicating the type of device that reported itself

(in this case, a 2-Wire Wall Switch):

Unlike Keypads and Occupancy Sensors, Dimmers and Switches do not utilize the

Device Integration ID value.

FIG. 34 CCD-RS switch

FIG. 35 NXB-CCG WebConsole - Add Devices page (Add/Remove Devices button)

FIG. 36 NXB-CCG WebConsole - Entering add/remove devices mode

FIG. 37 NXB-CCG WebConsole - Add/remove devices mode active

Status LED

Main "Paddle" button

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Sin comentarios

AMX RPMLoader Manual de usuario Pagina 15