AMX RPMLoader Manual de usuario descargar pdf (Pagina 14)

Configuring the NXB-CCG

RPM Device Configuration Guide - NXB-CCG NetLinx Clear Connect Gateway

The program will indicate that it is entering "add/remove devices mode" (FIG. 29):

In this mode, the NXB-CCG will wait for a device to be identified.

When "add/remove devices mode" is active, the WebConsole will prompt you to press and hold a button on

the sensor (FIG. 30):

2. To add the dimmer, press and hold the main paddle button (see FIG. 27) for approximately 4 seconds, until the

Device Heard popup appears in the WebConsole (FIG. 31) indicating the type of device that reported itself (in this

case, a Wall Dimmer):

3. Enter a unique name for the dimmer and click the Add button. This closes the Device Heard popup and returns to

the Add Devices page, still in "add/remove devices mode".

4. Click Done to exit "add/remove devices mode" (FIG. 32):

5. Note that the dimmer is now indicated in the Devices list. In the example shown in FIG. 33, the dimmer added was

named "Dimmer":

FIG. 28 NXB-CCG WebConsole - Add Devices page (Add/Remove Devices button)

FIG. 29 NXB-CCG WebConsole - Entering add/remove devices mode

FIG. 30 NXB-CCG WebConsole - Add/remove devices mode active

FIG. 31 NXB-CCG WebConsole - Device Heard popup (Wall Dimmer)

FIG. 32 NXB-CCG WebConsole - Exiting "add/remove devices mode"

FIG. 33 NXB-CCG WebConsole - "Dimmer" added

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sin comentarios

AMX RPMLoader Manual de usuario Pagina 14