AMX MAX-CSD 10 Manual de usuario

1 ControlSpace® Designer v3.244 Release Notes This release of ControlSpace Designer includes the following major new feature and function improveme

10 38. An issue that prevented ControlSpace Designer from reflecting changes made to numerical parameters of the PM8500N via serial command has been

11 2. The PM8500/N Recovery Mode is now correctly supported via USB allowing a new firmware image to be sent in the event of corruption or update fai

12 20. Open circuit detection relies on program material for impedance testing, and due to varying program material may not always work on some chann

13 38. It is no longer possible to set the network address in CSD to an inaccessible range. (#6589) 39. When power to the PM8500/N was lost the ‘A

14 2. New Signal Processing Modules In addition, to the features described above, new signal processing modules have been added for both PowerMatc

15 7. Presets retired, use Parameter Sets In order to simplify and streamline the available programming options Presets have been removed and are n

16 4. With multiple ESPs in the project and groups controlled via a CC-64, the CC-64 display could be slow to update if the encoder was turned quickl

17 19. In previous versions when multiple devices or modules were copied and pasted the labels were assigned in an unexpected order. This has now bee

18 timeout values are 10 seconds for a CC16 and 30 seconds for a CC64. The backlight time for a CC64 can still be adjusted on the hardware by pressin

19 1. Serial Get/Set IP Address command - The IP address of an ESP can now be read and set via the serial port using the command “IP”. See Serial Pro

2 CHANGES AND BUG FIXES SINCE v3.147 1. Network Setup Modifications to accommodate switching between Network Interface Cards.7190 2. Prevented lon

20 Bug Fixes 1. EQ groups that span multiple ESPs now track correctly when off-line. 2. A carriage return (CR) is no longer automatically append

21 6. Daylight Savings Time - The system will automatically apply daylight savings time to your timers if “Automatically adjust clock for daylight sa

22 20. The labels of each ESP in the “Select ESP to Download” dialog box have been corrected to all be unique. 21. An issue relating to the editing

3 but same IP/IDs. 7090 34. PM8500 signal generator's frequency spinners no longer stick when held down while online via USB. 6907 35. Added L

4 the CSD network and the project file network address. 6946 67. Duplicate PowerMatch Input & Output block labels are now changed to '----&

5 14. Depending on the number of ESPs in a project it is possible for Group volume adjustment via CC-16 to become a little ‘jumpy’. (#6525) 15. Mute

6 42. Connecting with CSD may cause the ESP to drop 3rd party Ethernet connection (e.g. AMX/Crestron). 7141 P2 43. The Bypass All button in the Param

7 To allow a larger number of PowerMatch PM8500N amplifiers to be monitored simultaneously a new ‘Status Panel’ is available. The panels are availabl

8 5. Previously, if CC64s were missing from the network at power-up or when the design is sent to PM8500N hardware, communication with the amplifier

9 22. The gain parameter of the ESP SpeakerPEQ module was internally limited to +12dB and did not reach the maximum level of +15dB shown in ControlS