AMX RMS CODECRAFTER Información técnica Pagina 193

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 374
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 192
Configuration Page
175
RMS Administrator’s Guide
Configure Notification Template (Cont.)
Device - device that
contains the
parameter change
that invoked the
notification
[Device.Description] - Device textual description
[Device.DPS] - Device:Port:System identifier
[Device.Manufacturer] - Device manufacturer name
[Device.Model] - Device model name/number
[Device.Name] - Device name
[Device.NetLinxDeviceAddress] - NetLinx device address
[Device.NetLinxDeviceAddressType] - NetLinx device address
type, e.g. "RS-232" , "TCP/IP" , "AXLINK" or "ICSNET"
[Device.NetLinxDeviceSerialNumber] - The serial number for the
NetLinx device
[Device.NetLinxDeviceType] - The NetLinx device type name.
e.g. "Volume Control" or "NI Master"
[Device.NetLinxDeviceVersion] - The version of the NetLinx
device
[Device.SerialNumber] - Device serial number
Formatting
[CRLF] - Carriage Return & Line Feed ( 0x0D, 0x0A )
[TAB] - Tab ( 0x09 )
Parameter -
parameter change
that invoked the
notification
[Parameter.LastUpdate] - The UTC time the parameter was last
updated
[Parameter.Name] - The parameter textual name
[Parameter.OriginalValue] - The original parameter value before
the parmaeter change
[Parameter.ParameterType] - The paramter type, e.g. "Numbwe"
or "String"
[Parameter.StatusType] - The paramter's status type. e.g. "Help
Request" or "Control System Error"
[Parameter.Threshold] - The parameter's threshold value, the
value that will be compared against to determine if the
parameter change has tripped the parameter
[Parameter.ThresholdCompare] - The parameters threshold
comparison expression that is used to determine if the
parameter change has tripped the parameter
[Parameter.Units] - The units of measure for the parameter, e.g.
"hours", "minutes" etc.
[Parameter.UpdateValue] - The update value of the last
parameter change
[Parameter.Value] - The current value of the parameter after the
parameter change has been applied
Vista de pagina 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 373 374

Comentarios a estos manuales

Sin comentarios