
TPI-PRO/DVI Configuration Pages
65
TPI-PRO/DVI (Total Presentation Interface)
If you have selected Composite or S-Video, the Video Settings Page contains the options shown in
FIG. 64.
FIG. 64 Setup - Video Settings Page (Input Type = Composite or S-Video)
Setup - Video Settings Page
Input: Press to cycle through the options for video input types: Composite 1/2/3, S-Video,
Computer (VGA), Component (YPrPb), and DVI (TPI-PRO-DVI only).
Composite 1/2/3:
• Composite 1 = Corresponds to a signal connected to the Red connector on the
DVI-to-3RCA Male adaptor cable.
• Composite 2 = Corresponds to a signal connected to the Green connector on the
DVI-to-3RCA Male adaptor cable.
• Composite 3 = Corresponds to a signal connected to the Blue connector on the
DVI-to-3RCA Male adaptor cable.
Default = Composite 1
Note (TPI-PRO-DVI only): When using a DVI source, set the input to DVI before
attaching the DVI cable to the TPI-PRO-DVI. If a DVI source is attached before setting
the input to DVI, you may need to reboot the source for it to recognize the DVI input
description information required by the DVI standard.
Resolution: Press to open the Input Resolution Popup Page, to adjust the TPI-PRO/DVI’s Input
Resolution setting (see the Configuring the Input Resolution (VGA & Component
only)) section on page 69).
Status: This read-only field indicates whether a video-sync signal is detected.
Version: This read-only field indicates the firmware version currently loaded on the TPI-PRO/DVI.
Auto Adjust: Press to toggle between Auto detection and Manual setup.
• This option is only valid for VGA and Component Input signal types.
• Default = Auto
Black & White: Press to toggle Black & White display mode.
• This option is only valid for Composite and S-Video Input signal types.
• Default = Off
Incoming Video Signal
window
Comentarios a estos manuales