AMX TPI-PRO-2 Especificaciones descargar pdf (Pagina 48)

Configuring Communication Settings

TPI-PRO/DVI (Total Presentation Interface)

Choosing the Master Connection Mode

Use the options in the Master Connection section of the System Settings page (FIG. 44) to specify the

communication parameters for the target Master.

Master Connection Mode Options

There are five Ethernet MODE settings available:

 URL (Uniform Resource Locator) is the address that defines the route to a file on the Web or any

other Internet facility. In this system, the TPI-PRO/DVI acts essentially as a "Client" and the

Master acts as a "Server".

This is the recommended setting for most situations.

 LISTEN sets the TPI-PRO/DVI to "listen" for connections from the Master (using the panel IP

from its URL list). In this system, the TPI-PRO/DVI acts as a "Server" (in that Clients attach to it)

and the Master acts as a "Client".

 AUTO (default setting) is used to instruct the TPI-PRO/DVI to search for a Master that uses the

same System Number (assigned within the Master Connection section) and resides on the same

Subnet as itself.

AUTO should only be used in systems with a single NetLinx Master on the network.

 NDP (UDP) uses multicasting to allow devices to discover each other. The devices must be on a

network that allows multicasting and is setup so that if the device and the Master are on separate

subnets, the multicasting allows them to discover each other.

 URL (UDP) is the address that defines the route to a file on the Web or any other Internet facility.

In this system, the panel acts as a "Client" and the Master acts as a Server (in that Clients attach to

it). In this case, the Master has its UDP feature enabled.

FIG. 44 System Settings page - Master Connection options

Press to cycle through Master Connection Mode options:

URL (recommended)

LISTEN

AUTO (default)

NDP (UDP)

URL (UDP)

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 193 194

Sin comentarios

AMX TPI-PRO-2 Especificaciones Pagina 48