AMX TPI-PRO-2 Especificaciones Pagina 159

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 158
Upgrading Firmware
157
TPI-PRO/DVI (Total Presentation Interface)
Upgrading Firmware
Overview
The process of updating firmware requires a communicating NetLinx Master.
The steps for updating firmware to a TPI-PRO/DVI are virtually identical to those necessary for updating .KIT
files to a NetLinx Master, except that the target device is a "panel" instead of a Master. Refer to either your
Master’s literature or NetLinx Studio online help for those instructions.
Use the Firmware Transfers utility in NetLinx Studio to transfer firmware upgrades to the TPI-PRO/DVI. In
NetLinx Studio, select Tools > Firmware Upgrades > Send To NetLinx Device to access the Send To
NetLinx Device dialog shown in FIG. 81:
Before beginning the firmware upgrade process:
Setup and configure your NetLinx Master. Refer to your particular NetLinx Master instruction
manual for detailed setup procedures.
Select the correct resolution, touch drivers, and calibrate the TPI-PRO/DVI (see the Calibrating the
TPI-PRO/DVI section on page 36).
Configure your TPI-PRO/DVI for direct communication (see the Configuring TPI-PRO/DVI IP
Settings section on page 44 for details regarding Ethernet communication).
Verify that the TPI-PRO/DVI is powered and connected to the NetLinx Master via Ethernet.
FIG. 81 NetLinx Studio - Firmware Transfer Tool - Send to NetLinx Device dialog
A TPI-PRO/DVI which is not using a valid username and password will not be able to
communicate with a secured Master.
If you are updating the firmware on a TPI-PRO/DVI which is not using a username or
password field, you must first remove the Master Security feature to establish an
unsecured connection.
Vista de pagina 158
1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 193 194

Comentarios a estos manuales

Sin comentarios