
KI-1856C Rauland RANGER
®
Head End—
Installation
Page 7 of 55 (Jun-98)
2.
Insert the
RANFT4
or
RANFT4FM
into the front of the card cage using the two metal
card guides (located on the top and bottom of the card cage) until it snaps into place.
3.
Connect a
BNC
-to-
BNC
75 Ω video cable (see drawing
VW
2375) from the
BNC
jack on
the
RANFT4
or
RANFT4FM
to one of the output jacks of the
RAN
[xx]
VS
[yy] Video
Matrix Switch.
Figure 1. Wiring for Fiber Transmitters.
1.
Connect the appropriate multimode fiber-optic cable strand to the
RANFT4
or
RANFT4FM
's designated output's fiber jack. The eventual destination of this strand will
be the Optical Input jack on the
RANFR1
or
RANFR1FM
(as shown in the figure
above). Note that all connectors for the fiber-optic cables must be the ST type.
Comentarios a estos manuales