AMX NI-2000 Guía de usuario descargar pdf (Pagina 17)

Introduction

NI-2000, NI-3000, NI-4000 Hardware Reference Guide

NI-4000 Specifications (Cont.)

Rear Panel Connectors (Cont.):

Program port • RS-232 DB9 connector (male) can be connected to a DB9 port on a

computer; used with serial commands, NetLinx programming commands,

other DB9 capable devices, and to upload/download information from the

NetLinx Studio 2.4 program.

Configuration DIP switch • Sets the communication parameters for the Program port.

ID pushbutton • Provides the NetLinx ID (Device only) assignment for the device.

• The D notation is used to represent a device number.

• Refer to the NetLinx Integrated Controller WebConsole & Programming

Guide for details.

Ethernet port • RJ-45 port for 10/100 Mbps communication. This port automatically

negotiates the connection speed (10 Mbps or 100 Mbps) and whether to

use half duplex or full duplex mode.

Ethernet Link/Activity LED • LEDs show communication activity, connection status, speeds, and mode

information:

SPD (speed) - Yellow LED lights On when the connection speed is 100

Mbps and turns Off when the speed is 10 Mbps.

L/A (link/activity) - Green LED lights On when the Ethernet cables are

connected/terminated correctly, and blinks when receiving Ethernet data

packets.

AXlink LED • Green LED indicates the state of the AXlink connector port.

• Normal AXlink activity = 1 blink/second

• Abnormal AXlink activity = cycle of 3 consecutive blinks and then Off

AXlink port • 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to

external control devices.

Power port • 2-pin 3.5 mm mini-Phoenix (male) connector

CardFrame Number

DIP switch

• Sets the starting address for the Control Cards in the CardFrame.(Factory

default CardFrame DIP switch value = 0).

• The Control Card address range is 1-3064.

NetLinx Control Card

connectors (1-4)

• Four 20-pin (male) connectors that bridge the gap between the Control

Cards in the CardFrame and external equipment.

Included Accessories: • 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)

• 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)

• 10-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5107)

• Installation Kit (KA2105-01):

8-pin Relay Common Strip

Four rack mount screws

Four washers

• NI-4000 Quick Start Guide

• Two 8-pin 3.5 mm mini-Phoenix (female) Relay connectors (41-5083)

• Two CC-NIRC IR Emitters

• Two removable rack ears (62-2105-07)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comentarios a estos manuales

Sin comentarios

AMX NI-2000 Guía de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Cajas De Interruptores En Serie AMX NI-2000