AMX NXB-CCG-K Información técnica descargar pdf (Pagina 51)

Lutron® integration protocol

NOTES

1. AREA can only be used to control areas of a QuantumR system that have been assigned to a particular

integration access point. Please refer to the Q-DesignT software (Integration Tab) or QuantumR Integration

Report for details of what areas are available for control and monitoring.

2. AREA commands cannot be sent to areas that contain other areas, such as a ﬂoor or an entire building.

3. The Level is accepted as a percentage.

4. The Fade and Delay time are optional. When not used the system will use a one second fade time with zero

second delay. The minimum fade and delay time is 0 seconds. The maximum fade and delay time is 4 hours.

5. Fractional seconds “SS.ss” will be rounded down to the nearest quarter second. For example, if a fade time

is speciﬁed as 1.45 seconds a value of 1.25 seconds will be used.

6. When a Raise / Lower command is issued, the area’s level will continue to go towards high end / low end until

a Stop command is received.

7. Scene 0 is the Off Scene.

8. If After Hours is used in an area, setting the area’s Occupancy Mode to “Occupancy and Vacancy” or

“Vacancy” will activate After Hours.

9. The area will report “Not Applicable” as its Occupancy Mode if the area does not have occupancy sensors

and if After Hours is not used.

Quantum® System Commands (continued)

QSE-CI-NWK-E: AREA Commands (continued)

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 136 137

Sin comentarios

AMX NXB-CCG-K Información técnica Pagina 51