AMX NI-3100 Especificaciones descargar pdf (Pagina 18)

Initial Configuration and Firmware Upgrade

NetLinx Integrated Controllers- WebConsole & Programming Guide (FMv3)

Obtaining the NI Controller’s IP Address (using DHCP)

1. In NetLinx Studio, select Diagnostics > Network Addresses from the Main menu to access the Network

Addresses dialog (FIG. 7).

2. Verify that both the System number corresponds to the System value previously assigned within the

Device Addressing tab and that zero (0) is entered into the Device field.

3. Click the Get IP Information button to configure the on-board Master for DHCP usage and then read the

IP Address obtained from the DHCP Server.

4. Note the obtained IP Address (read-only). This information is later entered into the Master

Communication Settings dialog and used by NetLinx Studio v 2.x to communicate to the NI Controller

via an IP. This address is reserved by the DHCP server and then given to the Master.

5. Verify that NetLinx appears in the Host Name field (if not, then enter it in at this time).

6. Click the Use DHCP radio button from the IP Address section.

7. Click the Set IP Information button to retain the IP Address from the DHCP server and assign it to the

on-board Master. A popup window then appears to notify you that Setting the IP information was

successful and it is recommended that the Master be rebooted.

8. Click OK to accept the change to the new IP/DNS information.

9. Click the Reboot Master button and select Yes to close the Network Addresses dialog.

Verify there is an active LAN connection on the NI Controller’s LAN port before

beginning these procedures.

FIG. 7 NetLinx Studio: Network Addresses dialog (for a DHCP IP Address)

System Address

reflects the value

set in the Device

Addressing tab

Used to obtain a

Dynamic (DHCP)

IP Address

The system value must correspond to the Device Address entered in the Device

Addressing dialog. Refer to the Manage System - System Number section on

page 39 for more detailed instructions on setting a system value.

DO NOT enter ANY IP information at this time; this step only gets the System Master

to recognize that it should begin using an obtained DHCP Address.

If the IP Address field is empty, give the Master a few minutes to negotiate a DHCP

Address with the DHCP Server, and try again. The DHCP Server can take anywhere

from a few seconds to a few minutes to provide the Master with an IP Address.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 159 160

Sin comentarios

AMX NI-3100 Especificaciones Pagina 18