AMX APWeb Manual de instrucciones Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 34
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
Overview and Specifications
9
Instruction Manual – Precis DSP Matrix Switchers
Overview and Specifications
Applicability Notice
Precis DSP Distribution Matrices are available in two configurations: 8x8 and 18x18.
Precis DSP Models:
FGP37-0808-00P, 8x8 (1 RU)
FGP37-1818-00P, 18x18 (2 RU)
In addition to being a stereo audio router, this product supports Digital Signal Processing (DSP) for the following audio
features: volume, tone, balance, 10-band graphic equalization, and input gain. These features can be adjusted by using
the APGraphic EQ software program (or BCS commands).
Product Notes
Note: Because the Precis DSP is available in two models, some of the illustrations in this manual may differ
from the model you purchased.
Precis DSP systems support the following features:
Precis DSP Features
10-Band graphic equalizer with APGraphic EQ setup software
Balance, tone, and volume control
Input gain control
Unbalanced stereo audio
Gold-plated RCA connectors
RS-232 control port
Supports full Device Discovery through AMX’s AutoPatch Duet module (firmware v1.2.0 or later required)
Rack mounting ears included
Limited Warranty (see warranty at www.amx.com)
24-hour technical support
Precis DSP Control Features
Precis DSP systems support two different protocols: BCS (Basic Control Structure) and TCP/IP.
Several different control options are available for Precis DSP system. Multiple control methods can be used for the same
system (only one control connection at a time).
CrossBar Controller on APGraphic EQ (software provided)
AMX Control Device (for control programming information, see the instruction manual for the specific
interface)
APControl 3.0 software (available free at www.amx.com)
APWeb (TCP/IP control via an external module)
Supports AMX’s simple BCS* (Basic Control Structure) serial control protocol
Supports third-party controllers
* BCS is sent as ASCII characters through the CONTROL (RS-232) serial port (see page 29).
Note: Features and specifications described in this document are subject to change without notice.
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Comentarios a estos manuales

Sin comentarios