AMX APWeb Manual de instrucciones descargar pdf (Pagina 30)

Controlling the System

Instruction Manual – Precis DSP Matrix Switchers

Executing a Test Switch with BCS

The following test switch routes Input 2 to Output 1 (the level does not need to be specified since the Precis DSP only

switches audio).

To execute a test switch using BCS commands:

Enter the following BCS command line:

CI2O1T

When the “T” appears, the system has successfully executed the command. If any other characters appear, the command

was not successful. Verify that the source signal is audible at the destination.

Important: When entering values for BCS gain commands, do not

add any leading zeros (e.g., to set the

volume to -9 dB, enter CO3VA-90T, do not enter CO3VA-090T).

Troubleshooting

If the test switch did not execute correctly:

Check the power indicator on the front of the enclosure.

If it is not illuminated, check the power cords.

Verify the status of the test switch.

If using BCS commands, enter “SO1T”. If “SO1T(2)” appears, the test switch is routed.

1 2 ... 25 26 27 28 29 30 31 32 33 34

Sin comentarios

AMX APWeb Manual de instrucciones Pagina 30