AMX AVB-WP-TX-MULTI-DXLINK Manual de instrucciones Pagina 21
- Pagina / 154
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Product Overview and Specifications
15
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Multi-Format TX Rear View
HDMI TX Rear View (product discontinued)
Note: The Multi-Format TX and HDMI TX each have a DIP switch on the bottom (see page 21).
The following components are located on the rear of the Multi-Format TX and HDMI TX Modules
(from left to right):
Video In Connector (Multi-Format TX only)
The Video In connector on the Multi-Format TX is an HD-15 connector for analog video (composite,
Y/c, Y/Pb/Pr, RGB, RGBHV, or RGBS). Pinouts for analog video are on page 128.
Note: When an analog video source cable is plugged into the Multi-Format TX, the Video LEDs on
the front and on the Receiver turn green to show that video is present through the system. In
addition, one of the Analog Video LEDs on the front of the Multi-Format TX and the HDMI RX turns
green to show the type of video that is present through the system.
HDMI In Connector
The HDMI In connector is for digital video and embedded digital audio. When more than one audio
signal is present and the default “auto” mode is enabled, HDMI embedded audio takes precedence over
S/PDIF and analog audio.
When a NetLinx Central Controller is connected, an audio format SEND_COMMAND is available (the
Transmitter must be set for network connectivity via #3 Toggle) to select the desired audio source (see
page 90).
The HDMI connector has a center screw for locking capability. The HDMI connector also supports a
DVI-D signal with the use of a DVI-to-HDMI cable adapter.
Note: When a digital video source cable is plugged into the HDMI connector, the Video LEDs on the
front of the Multi-Format TX or HDMI TX and Receiver turn green to show that video is present
through the system.
FIG. 5 Multi-Format TX rear view
FIG. 6 HDMI TX rear view
IR ports
RS-232 port
HDMI In connector
Stereo Audio In jack
USB port
ICS LAN 10/100 connector
Power jack
DXLink output connector
Digital Audio In jack
Video In connector
Ground screw
IR ports
RS-232 port
HDMI In connector
Stereo Audio In jack
USB port
ICS LAN 10/100 connector
Power jack
DXLink output connector
Digital Audio In jack
Ground screw
- Twisted Pair 1
- Transmitters/Receiver 1
- Contents 3
- ESD Warning 7
- Copyright Notice 10
- Liability Notice 10
- US FCC Notice 10
- Lithium Batteries Notice 11
- Trademark Notices 11
- Warnings and Cautions 11
- Applicability Notice 13
- Product Notes 13
- Product Compatibility Tables 14
- Common Applications 16
- Transmitters 16
- Multi-Format TX front view 16
- HDMI TX front view 16
- (Blinking = #3 Toggle OFF) 17
- Multi-Format TX rear view 21
- HDMI TX rear view 21
- Receiver 24
- HDMI RX front view 24
- HDMI RX rear view 25
- Common Features/Functionality 27
- HDCP Compliance 28
- General Specifications 31
- Shielded Cat6, Cat6A, Cat7* 32
- qualified): 1 per module 33
- Audio Format 34
- Analog Video Specifications 36
- Local Audio Specifications 37
- Installation and Setup 39
- Setup Information 40
- Example B 43
- Example C 43
- Example D 43
- Example A 43
- DXLink connections 44
- Avoid network loops 46
- V Style mounting hardware 50
- ICS LAN 10/100 LEDs 54
- (modules only) 54
- NetLinx LEDs 55
- DXLink LEDs 55
- Audio Type Precedence 56
- Important: Do not 57
- Rear view 57
- Front view 57
- HDMI RX – Applying Power 62
- IR Receiver cable (FG-IR03) 64
- ID Pushbutton Functions 65
- Manual Mode 66
- DXLink Transmitter 68
- Network Configuration 69
- TCP/IP Address Configuration 70
- Factory Default Parameters 71
- Device IDs 72
- Using the ID Pushbutton 72
- LED columns 77
- IRL File Transfers 79
- Transferring IRL Files 82
- Additional Documentation 84
- Device Numbering and Ports 85
- Overview 85
- CHANNELs 87
- Aspect Ratio Options 89
- VIDIN_PREF_EDID 93
- IR SEND_COMMANDs 97
- GET MODE 98
- Serial SEND_COMMANDs 101
- DXLink System SEND_COMMANDs 104
- SEND_STRING Escape Sequences 105
- Troubleshooting 107
- Determining HDCP Compliance 108
- Power Issues 108
- DXLink Connection Issues 109
- Network Setup Issues 110
- Technical Support 110
- Extender System (Standalone) 111
- Important Upgrade Information 114
- Transferring KIT Files 115
- Telnet Username and Password 118
- Telnet Commands (continued) 120
- Master Connection Modes 125
- Windows Client Programs 126
- Linux Telnet Client 126
- Receivers is 192.168.1.2) 127
- Creating a Virtual Master 129
- Click to open the 129
- Communication Settings 129
- CONNECTION and press Enter 132
- HD-15 Connector Cable Pinout 134
- DVI-I signal is required 135
- SEND_COMMANDs 141
- CEA (RGB Color Space): 142
- CVR (RGB Color Space): 143
- CVT (RGB Color Space): 144
- DMR (RGB Color Space): 145
- DMT (RGB Color Space): 145
- Applicability 147
- Remove jackscrew and washer 148
- Appendix H – EDID Programming 149
- DXLink Connection to PC 150
- EDID Programmer View 151
- 06/20/13 154
Relacionado con productos y manuales para Transmisores De Pared AMX AVB-WP-TX-MULTI-DXLINK
(24 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 2.206 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales