AMX AXT-CV10 Especificaciones descargar pdf (Pagina 51)

Installation

10" Modero Widescreen Touch Panels

Installing the NXD into drywall using Expansion Clips

Expansion clips are mounted through the three oval holes located along the rim of the NXD-CV10. As

the screw is tightened, the clip bends toward the insertion hole and into the wall. This bending creates a

"grip" on the wall by either pressing onto the wall or by securing the drywall between the housing and

the drywall clip.

The most important thing to remember when mounting the NXD is that the outer frame (Mounting Tabs)

must be installed flush against the mounting surface.

 Refer to SP-2259-03 for detailed installation dimensions (reproduced in FIG. 40).

 It is recommended that you cutout the surface slightly smaller than what is outlined in the

installation drawings so that you can make any necessary cutout adjustments.

1. Prepare the area by removing any screws or nails from the drywall before beginning the cutout

process.g.

2. Cut out the drywall surface for the NXD Wall Mount unit using the dimensions shown in FIG. 40.

Be sure to cut out the three notches along the sides to accommodate the three corresponding drywall

expansion clips (included).

3. Remove the Faceplate/bezel (A in FIG. 41) from the main NXD unit (B in FIG. 41) by gripping the

faceplate and pulling with gentle outward force.

FIG. 40 NXD-CV10 Wall Mount panel dimensions using expansion clips

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 219 220

Sin comentarios

AMX AXT-CV10 Especificaciones Pagina 51