AMX NetLinx NXB-KNX Manual de instrucciones descargar pdf (Pagina 43)

Cross-Line Communication

NXB-KNX KNX Communications Gateway

Cross-Line Communication

Overview

In many cases cross-line communication is required. In order to enable cross line communication a KNX programmer

will need to utilize the AMX NXB-KNX Virtual Device. This ETS device entry will serve as the

NXB-KNX device in ETS3.

The NXB-KNX is not a native KNX device and so it cannot be directly programmed from within ETS3. The AMX

NXB-KNX Virtual Device will allow a programmer to configure cross line communication between KNX devices and

the NXB-KNX.

The AMX NXB-KNX Virtual Device, once configured as desired, will allow ETS3 to calculate the appropriate routing

tables for line and area couplers.

Integrating the NXB-KNX Virtual Device Into An ETS3 Project

The following are the basic steps for integrating the NXB-KNX Virtual Device into an existing ETS project:

1. Open an existing ETS3 project.

2. Select File > Import to invoke the Import dialog (FIG. 23):

3. Locate and select the NXB-KNX Virtual Device.vd4 file, and click Open.

This action invokes the Selective Import dialog (FIG. 24):

FIG. 23 ETS3 - Import dialog

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Sin comentarios

AMX NetLinx NXB-KNX Manual de instrucciones Pagina 43