AMX NXF Especificaciones descargar pdf (Pagina 21)

NXC-I/O10 Input/Output Control Card

NetLinx Cardframe, Control Cards, and NetModules

NXC-I/O10 Input/Output Control Card

The NXC-I/O10 Input/Output Control Card (FG2021) provides 10 Input/Output channels and LED feedback.

It acts as a logic-level input and responds to switch closures or voltage level (high/ low) changes. The Switch

(SW) and Voltage (VO) modes are set with on-board jumpers. FIG. 4 shows the I/O10 card.

The I/Os do work with AMX PC1, PC2, UPC20 and UPC20+.

Specifications

The I/Os on this card are not dry closure; they are electronic switches that float at 5V

when Off. Therefore, they should not be expected to work in situations that require

true dry contact (or dry closure).

FIG. 4 NXC-I/O10 Control card

NXC-I/O10 Specifications

Power Requirements 180 mA @ 12 VDC

Operation I/O 1-10: ten Input/Output channels

Status LEDs (1 per channel Yellow LEDs light to show ON status activity

Modes:

Switch Senses switch or relay contact closures or provides a logic-level output.

Voltage Senses high- and low-voltage states.

Voltage clamp settings:

12 V mode (default) Clamps any voltage connected to I/O ports 1-10 to 12 V.

VO mode Use for connections that will draw more than 12 V.

Connections/wiring Two 10-pin 3.5 mm captive-screw terminals

SW/VO Jumpers (J1 - J5)

V-Clamp +12V/Open Jumper (J31)

SW/VO Jumpers (J16 - J30)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 49 50

Sin comentarios

AMX NXF Especificaciones Pagina 21