Amx ENV-VST-C Manual de usuario descargar pdf (Pagina 22)

Installation and Wiring

ViewStat Color Communicating Thermostat

Installing the Indoor Flush Mount Sensor

FIG. 13 displays the two pieces of the indoor flush mount sensor. The two pieces are the sensor body

with the connected wire and the threaded outer case of the sensor.

FIG. 13 Indoor Flush Mount Sensor

Follow these steps to install the indoor flush mount sensor:

1. Drill a ½" hole into the drywall where you want to install the sensor.

2. Fish the cable that connects to the sensor from behind the drywall and out through the ½" hole so

that 6" - 12" of the cable hangs through the hole.

3. Feed the sensor wire through the center of the threaded outer case of the sensor and connect it to the

cable that is hanging through the hole in the wall as shown in FIG. 14.

FIG. 14 Sensor wire connected to cable

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Sin comentarios

Amx ENV-VST-C Manual de usuario Pagina 22