
•CBL-HDMI-FL HDMI, High Speed Flat Cable with
RedMere® Technology (FG10-2180-16)
•CBL-DP-FL, DisplayPort High Speed Flat Cable with
RedMere Technology (FG10-2181-16)
•CBL-ETH-FL, Ethernet Cat5e Flat Cable (FG10-2182-
16)
•CBL-RGB+A-FL RGB with Audio Flat Cable (FG10-
2183-16)
ACTIVE POWER REQUIREMENTS
90 Watts typical without amplifier
95 to 100 Watts typical average with amplifier
30 Watts typical in low-power mode
Power Factor Correction (PFC)
Supported, complies with N60555-2 and EN61000-
3-2
0° C to 40° C (32° F to 104° F)
-10° C to 70° C (14° F to 158° F)
Heat Dissipation (Typical)
Heat Dissipation (Standby)
10/100 Port RJ-45 connector provides TCP/IP
communication. This is an Auto MDI/MDI-X enabled
port, which allows you to use either straight-through
or crossover Ethernet cables. The Ethernet Port LEDs
show communication activity, connection status,
speeds, and mode information
Link/Activity LED (green) blinks when receiving
Ethernet data packets, one on Ethernet RJ-45
connector and one on the front panel
Speed LED (yellow) lights On when the connection
speed is 100 Mbps Ethernet connection and turns OFF
when the speed is 10 Mbps
DVX-3156HD-SP: 2 x 25 W RMS into 8 Ohms Class D
stereo amplifier (4-ohm stable)
DVX-3156HD-T: 75 W, 70 V / 100 V mono amplifier
Integrated Controller is the equivalent of a NetLink NI-
3101-SIG Central Controller
1 MB Non-volatile (NV) SRAM
4 GB FLASH
(1) DB-9 connector that supports RS-232
Comentarios a estos manuales