AMX OLDesign Manual de instrucciones descargar pdf (Pagina 11)

Installation

P+ Softwire Panels

6. Snap engraved faceplate into magnetic bezel.

7. Set the DIP switches for the AXlink device code assigned to the unit. The device code number

is a function of the switches set in the ON position as shown in Figure 6.

8. Connect AXlink cables and power wiring as required. Attach the data and power wiring to the

Softwire Panel. (See Wiring the Panel.)

9. Test component and system operation.

10. Insert the engraved overlay back into the bezel.

FIG. 8 AXU-SP+ cutout dimensions for plasterboard

The Softwire Panel must always be installed with the release slot located at the bottom.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

AMX OLDesign Manual de instrucciones Pagina 11