AMX G3 Firmware Manual de instrucciones descargar pdf (Pagina 9)

Installation

Color Passive-Matrix LCD Touch Panels

2. Carefully insert a flat-blade screwdriver into the release slot on the touch panel’s bezel and

remove the engraved overlay.

3. Lay the touch panel facedown onto a soft cloth and remove the four screws from the low-

profile Back Box. Remove the Back Box and discard.

4. Place the BB-TP2 into the cutout and mark the threaded insert positions as shown in FIG. 3.

5. Remove the BB-TP2 and drill holes (A and B) for the panel (FIG. 3). Then, place #6-32

threaded inserts into the four holes marked 'B' in the cutout dimensions illustration.

6. Disconnect the AXlink connector from the Central Controller. Then, disconnect the optional

RS-232 wiring from the external RS-232 device connected to the touch panel.

7. Remove one or more knockouts to accommodate the wiring as required.

8. Thread the incoming AXlink and RS-232 wiring through the knockouts. Refer to theWiring the

Touch Panel section on page 8 for additional wiring information.

9. Fasten the BB-TP2 to the solid surface using the supplied mounting screws.

10. Connect the AXlink and RS-232 wiring to the touch panel.

FIG. 3 Decor style (AXD) and BB-TP2 cutout dimensions

The touch panel must always be installed with the release slot located at the bottom.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Sin comentarios

AMX G3 Firmware Manual de instrucciones Pagina 9