Amx RF Receiver AXR-RF Manual de usuario descargar pdf (Pagina 5)

Product Information

AXR-RF RF Receiver

Product Information

The AXR-RF Radio Receiver provides wireless reception of AMX radio frequency (RF)

transmitters. The AXR-RF connects to an Axcess Central Controller with an AXlink, 4-pin captive-

wire connector. When required for large areas, or multiple-room coverage, multiple receivers can

be connected in parallel on the AXlink bus.

Specifications

Power Consumption 780 mW; ±12 VDC, 65 mA (max.)

Dimensions (HWD) 1.5" x 5.09" x 5.27" (3.81 cm x 12.93 cm x 13.39 cm)

Weight 10.56 oz. (299.37 g)

Front Panel Components:

Radio data LED Red LED lights to indicate the AXR-RF has received an RF signal from an AMX

transmitter.

AXlink LED Green LED that lights to indicate AXlink power/data status as follows:

• One blink/second indicates power is active and AXlink communication is

working.

• Two blinks/second indicates the devices specified in the main program do not

match the devices found.

• Three blinks/second indicates there is an AXlink communication error

• Full on indicates there is either no AXlink control/activity (but the power is On)

or the Axcess program is not loaded.

Rear Panel Components:

AXlink connector 4-wire captive-wire AXlink connector for the Central Controller provides data

and nominal ±12 VDC power.

Device number 8-position DIP switch sets the device number for the AXR-RF.

RF antenna Receiving antenna screws into the TXC antenna connector. If it is necessary to

place the antenna in a remote position, use up to 6 ft. (2 m.) of RG-174 coax

cable as an extension. Extend the antenna vertically during use.

TXC antenna connector Antenna coaxial connector

Receive Frequency 418 MHz standard (other frequencies are available)

Maximum Range 300 feet (91.44 m)

Enclosure Molded black matte plastic

Options • Alternate frequencies available

• PS2.8 Power Supply

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Amx RF Receiver AXR-RF Manual de usuario Pagina 5