AMX DXLink Multi-Format Wallplate Manual de usuario descargar pdf (Pagina 3)

Shipping Weight

Approximately 1.3 lb (.61 kg)

MTBF

381,000 hours

Airflow

Natural convection via air vent openings on front, back

and top

Compatible AMX Products

•Enova DGX 8/16/32/64 Digital Media Switchers

•Enova DVX-3155HD, DVX-3156HD and DVX-2155HD

All-In-One Presentation Switchers

•DXLink HDMI RX as a point-to-point solution (when

Wallplates are powered by PS-POE-AT-TC or PDXL-2)

•PS-POE-AT-TC High Power PoE Injector

•PDXL-2 Power over DXLink Controller

Regulatory Compliance

FCC

CE EN 55022

CE EN 55024

CE EN 60950-1

IEC 60950-1

UL 60950-1

RoHS / WEEE compliant

Recommended Accessories

CC-USB, USB Programming Cable (FG10-5965)

DXLink TWISTED PAIR

Transport Layer Throughput (Max)

10.2 Gbps

Twisted Pair Cable Type

Shielded Cat6, Cat6A and Cat7

DXLink twisted pair cable runs for DXLink equipment

shall only be run within a common building where a

common building is defined as: the walls of the

structure(s) are physically connected and the

structure(s) share a single ground reference

For more details and helpful cabling information,

reference the white paper titled Cabling for Success

with DXLink, or contact your AMX representative

Twisted Pair Cable Length

Up to 328 ft (100 m)

ACTIVE POWER REQUIREMENTS

DXLink Power

Power must be supplied by a DXLink Power sourcing

device such as:

•Enova DGX 8/16/32/64 Digital Media Switcher (with a

DXLink Twisted Pair Input Board installed)

•Compatible Enova DVX All-In-One Presentation

Switcher (DVX-3155HD, DVX-3156HD or DVX-2155HD)

•PS-POE-AT-TC High Power PoE Injector

•PDXL-2 Power over DXLink Controller

When installed in conjunction with an Enova DGX use

the Enova DGX Configuration Tool located at

AMX.com/enova to determine the power

requirements of the configuration

AMX only supports the use of these approved Power

over DXLink solutions. Other third party

power supplies or non-compatible standard PoE

solutions may damage the DXLink equipment. To use

PS-POE-AT-TC or PDXL-2 as a power source the

wallplates require firmware v1.2.40 or above

Power Connector

Included on DXLink Connection

Power Consumption (Max)

Power over DXLink supplied: 7 W

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios

AMX DXLink Multi-Format Wallplate Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor AMX DXLink Multi-Format Wallplate