
Page 21 AMX Product Brief | ENOVA DGX 16, 32 & DXLink
FEATURE SUMMARY
HDMI/HDCP Switching with
Simplicity of Analog
End-to-end distribution of HDMI/HDCP without
interruption or key constraints
Eliminate the headaches and workarounds
to install devices requiring HDMI/HDCP
compliance
AV and Control over Twisted Pair
Send audio, video, bi-directional control and Ethernet
up to 100 meters over a single standard good quality
(250 Mhz or better rating) twisted pair cable
Reduce cable costs and simplify installation
of devices using standards-based cabling
Embedded NetLinx Controller
The DGX includes a built-in AMX NI-3100 NetLinx
Central Controller, which allows any connected device
to be managed, monitored or controlled
Easily program and manage the entire
solution including source equipment and
display devices located across multiple
rooms – all from a single point of control
Integrated Ethernet Switch
Pass Ethernet or stream IP video through the
attached DXLink Transmitter or Receiver
Reduce the complexity of larger
installations where sources and outputs
Analog to Digital Video
Conversion with Scaled Outputs
Converts any source signal to digital and uses
SmartScale Technology to automatically output video
that is perfectly scaled for each connected display
Interconnect devices of mixed formats
without adding cost of external converters
or increasing failure points
Comparatively speaking, it takes up half the space of
the competition
Take up less rack space and provide
flexibility on installation locations
Allows traditionally key limited sources to be freely
switched to any HDCP compliant display without the
typical HDCP delays
Easily integrate HDCP into system designs
and enjoy hassle-free matrix switching to
all compliant displays; no tools, no delays,
and no key constraints – it just works
Automatically responds to the display's declared EDID
information and scales the video to the best
resolution and video parameters for that display
without manual setup
Display optimal resolution on every display
with no image degradation in applications
with mixed resolution
DXLink Twisted Pair Input and
Output Boards
HDCP Compliant boards send audio, video, control,
Ethernet and power over one standard twisted pair
cable up to 200m – 100m to the matrix switcher and
100m after the matrix switcher
Reduce the complexity of larger
installations where sources and outputs are
installed far from the switcher
Hot Swappable Video Input /
Output Boards
Video I/O boards can be swapped and the system
automatically recognizes the new configuration and
activates the boards
Easily add or replace I/O boards at any time
after deployment
Audio Insert / Extract Boards
Add audio from a local source or breakaway
embedded audio and send to a separate audio system
to distribute throughout an environment
Flexible options for pairing audio with
video
Fiber Input and Output Boards
Use in conjunction with DGX Fiber Transmitters and
Receivers to send analog and digital audio and video*
over fiber
*Fiber input and output boards provide support for
non-HDCP signals only
Allows for distribution of audio and video
up to 1000m
Pass through the latest video formats including 3D
and Deep Color
Pass through high definition surround sound including
DTS-HD and Dolby TrueHD
Provides optimal audio quality
High Speed Digital Switching
Ensures perfect pixel for pixel reproduction
of video
Fully Redundant Power Supplies
With Independent Power Paths
Allows two separate power sources to send power to
the switcher
Ensures maximum reliability for
applications that require 24/7 uptime
Comentarios a estos manuales