AMX Network Device TX-CTB Manual de usuario descargar pdf (Pagina 10)

NI Wireless Sensor Network Devices 10 ni.com

Note If your node does not connect automatically, refer

ni.com/info and enter exxhqv for troubleshooting

information.

Step 5. Attach Sensors and Signal Lines

Attach sensors and signal lines to the terminal block or accessory

terminals for each device. For device pinouts, refer to the device

documentation.

Step 6. Start Using the NI WSN System

To use the NI WSN system, open a new LabVIEW project. If the

gateway is on the local subnet, complete the following steps:

1. Right-click the project name and select New»Targets and

Devices. In the Add Targets and Devices on My Project dialog

box, select Existing target or device and expand the

WSN Gateway folder. When you expand the WSN Gateway

folder, the network is scanned for any connected NI WSN

gateway devices. Wait for device detection.

2. Once detected, click the NI WSN gateway device you wish to

use and click OK. Clicking OK adds the NI WSN-9791 or

NI 9792 device to the Project Explorer window.

1 2 ... 5 6 7 8 9 10 11 12 13 14

Sin comentarios

AMX Network Device TX-CTB Manual de usuario Pagina 10