AMX AXP-AI8 ANALOG 8-INPUT BOARD Manual de instrucciones descargar pdf (Pagina 23)

Device Connectors

Instruction Manual - Solecis Digital Switchers

AXLINK KEYPAD Port (4-pin captive-wire)

The AXLINK KEYPAD port allows the switcher to provide power and data to up to two AMX AxLink Keypads.

AxLink functionality requires a NetLinx Master to be present on the connected network. The AXLINK KEYPAD LED

indicating activity on the port is located on the front panel of the device. See the LEDs section on page 14 for more

information.

FIG. 6 displays the AxLink ports on the SDX-410-DX and SDX-510M-DX.

FIG. 6 AxLink Ports

The AxLink port can be used to supply power to downstream AxLink-compatible devices. The port is capable of

providing at least 2 Amps of 12V power.

For information on wiring for the AxLink port, see the AXLINK KEYPAD Port section on page 25.

CONFIG DIP Switch

Use the Configuration DIP switch to enable/disable the LAN ports, set the DXLink mode, and set network connectivity.

All DIP switches are initially set to the OFF position. DIP switch settings are read on reboot. Any changes to the DIP

switch settings are not acted upon until after you reboot the device.

FIG. 7 displays the CONFIG DIP switch.

FIG. 7 CONFIG DIP switch

The DIP switches are numbered 1-4 from left to right. The following table lists the settings for each DIP switch.

DIP Switch Settings

Pin Description ON OFF

1 Enable/Disable LAN 10/100 Enables all External LAN 10/100

ports

Disables all External LAN 10/100

ports

2 Set the DXLink mode Maintains ability to read the DIP switch but takes no action. Always

responds to the ?DXLINK command as an endpoint.

3 Network Connectivity IP for the internal processor is

enabled. This switch does not

affect the External Ethernet

ports.

IP for the internal processor is

disabled. This switch does not

affect the External Ethernet ports.

4 Not Defined No action No action

SDX-410-DX

SDX-510M-DX

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 69 70

Sin comentarios

AMX AXP-AI8 ANALOG 8-INPUT BOARD Manual de instrucciones Pagina 23