Amx AXB-TM5 Manual de usuario descargar pdf (Pagina 7)

Connection and Wiring

AXB-TM5 Television Manager

Connection and Wiring

Device DIP Switch

The eight-position Device DIP switch, shown in FIG. 2, sets the AXlink device number. Every

device on the bus must have a unique device code. An eight-position DIP switch is used to set the

device number for the AXB-TM5. The device number must match the number assigned in the

Axcess software program. The AXlink device number range is 1-255 and is sent according to the

Device DIP switch positions and their values.

As an example, FIG. 2 is set to 85 (1 + 4 + 16 + 64 = 85), which is the factory default setting.

The following table describes the Device Code DIP switch settings and its corresponding DIP

switch arrangements.

AMX standard device numbers are assigned as follows:

! Cards are 1 through 25.

! Boxes are 96 through 127.

! Panels are 128 through 255.

After setting the AXlink device number, remove and reconnect the AXlink connector

on the AXB-TM5 to store the new number into memory.

FIG. 2 Device Code DIP switch setting example

Device DIP switch settings

Position 12345678

Value 1248163264128

The device number takes effect only on power-up. If you later change the device

number, remove and reconnect the AXlink connector. This enters the new device

number into memory.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Sin comentarios

Amx AXB-TM5 Manual de usuario Pagina 7