AMX NXB-CCG Especificaciones descargar pdf (Pagina 10)

Installation

NXB-CCG NetLinx® Clear Connect™ Gateway

Installation

1. Find a suitable location for the NXB-CCG.

2. Mount vertically or horizontally (FIG. 3), using two #6 (M3) screws. When mounting, allow 7 in (177.8

mm) clearance for the antenna and ensure convenient access to the power plug. In order to achieve proper

RF performance, do not mount unit in a metal enclosure.

3. Attach the DC adapter cord to the power jack on the NXB-CCG and insert the DC adapter plug into a

receptacle (FIG. 2).

4. Use CAT5 Ethernet cable to connect the NXB-CCG to the chosen network’s Master. Please refer to the

Ethernet Pin Numbering diagram (FIG. 5) for the correct connection.

5. Clip the included CAT5 Suppression Ferrite around the Ethernet cable (FIG. 4), 2 to 3 inches (51-76 mm)

from the NXB-CCG’s Ethernet port.

FIG. 3 Installation Diagram

FIG. 4 Installing the CAT5 Suppression Ferrite

Vertical

Horizontal

Wall

Level Surface

1”

2.54 cm)

#6 (M3) screws

recommended

12 3

(complete)

If the ferrite slips on the Ethernet cable, such as in a vertical installation, electrical or

duct tape may be wrapped around the cable to keep the ferrite in place.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

AMX NXB-CCG Especificaciones Pagina 10