AMX Modula Manual de instrucciones descargar pdf (Pagina 19)

Settings Pages

Modero G4 Touch Panels - Configuration and Programming

4. Follow the instructions, touching the crosshairs in order across the screen.

5. The page will read "Calibration Successful. Touch to continue." Touch anywhere on the screen to return to the

Calibration page.

In certain circumstances, you may wish to test the calibration of a panel without actually recalibrating it. The Calibration

Test page (FIG. 12) may be used to verify the accuracy of that calibration.

To calibrate the touch panel:

1. From the Settings page, select Display.

2. From the Display page, select Calibration.

3. To test the calibration of the touch panel, select Calibration Test to open the Calibration Test page (FIG. 12).

4. Touch the screen and note the positioning of the crosshairs based on where you touch.

5. If the crosshairs do not match the places where you touch, then go back to calibrate the panel.

Calibration Test

Unlike previous AMX touch panels, the Modero X and S Series panels are self-calibrated on startup. The Calibration

Test page (FIG. 13) may be used to verify the accuracy of that calibration.

To run a calibration test on the panel:

1. From the Settings page, select Display.

FIG. 11 Panel calibration

If the screen is not touched at that point, the device will automatically return to the

Calibration page within 10 seconds.

FIG. 12 Calibration Test page

FIG. 13 Calibration Test page

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 139 140

Sin comentarios

AMX Modula Manual de instrucciones Pagina 19